Prototype vs. Production Sun Gears: What Changes in the RFQ
Prototype and series sun gears should share one approved geometry, but tooling, inspection strategy and process economics can change as volume grows.
Why this topic changes the sun gear decision
Procurement is easier when prototype versus series supply is defined in a controlled record rather than scattered through emails. Geometry, interface, process, duty, acceptance and quantity should be distinguishable.
Prototype and repeat production can use different tooling or sampling strategies while keeping the same approved geometry.
Practical design and replacement implications
State which documents are required with shipment and whether a first-article or pilot approval is needed. Add destination and Incoterm so the commercial scope is clear.
For replacement sourcing, machine references support identification, but measured gear and interface data remain the production control.
What to control on the RFQ or drawing
| Элемент | What to define |
|---|---|
| Tooth system | Tooth count, module/DP, pressure angle, helix and profile shift/modification when applicable. |
| Planetary context | Mating planet/ring data and planet count when available. |
| Center interface | Bore, keyway, spline, hollow center or integrated shaft plus functional datums. |
| Долг | Rated/peak torque, speed, reversals/shock, life, lubrication and environment. |
| Процесс | Controlled material, heat treatment, finishing and coating requirements. |
| Acceptance | Tooth/runout/dimensional inspection and required documentation. |
Frequently asked questions
Can one loose sun gear answer every design question?
Usually not. Mating gear data and the center interface provide important cross-checks.
Should material or tolerance be copied from a similar part?
Only when the controlled design allows it. Similar appearance is not proof of the same duty or specification.
What is the fastest way to get a useful quote?
Send the latest drawing or measured tooth/interface data, mating component information, duty, acceptance needs and quantity.
Запросить ценовое предложение / Отправить запрос на коммерческое предложение
Send the drawing, mating gear information, center interface, duty, inspection needs and quantity. The article is selection guidance; the approved drawing controls production.
