How to Measure a Sun Gear for Replacement
When the original drawing is missing, build the replacement record from the gear mesh and the shaft interface.
Count first
Record the sun, planet and ring tooth counts and the number of planet gears.
Measure the interface
Capture bore/spline, shaft journals, shoulders, keyways, threads and retention features.
Do not infer tooth geometry from OD alone
Outside diameter is useful, but module/DP, pressure angle and profile shift need independent confirmation.
Photos help, measurements control
Send photos for identification context together with measured dimensions and the mating components.
Use the drawing as the controlled record
A technical guide can explain which variables matter, but the final sun gear must be approved from the actual drawing and operating requirement.
If a value is missing, identify it for confirmation instead of copying a dimension or material from a different supplier or gear family.
Daftar periksa RFQ
Send the sun gear drawing or measured tooth data, mating planet/ring information, interface dimensions, material/process requirements, duty, quantity and destination.
Deeper buyer guidance
Replacement measurement should separate original geometry from wear, damage and service-created deformation.
For new designs, use the complete planetary geometry and functional datums before deciding the process route. For replacement work, use photos and equipment references for context but let measured tooth and interface data control the new part.
What to control on the RFQ or drawing
| Barang | What to define |
|---|---|
| Planetary mesh | Sun, planet and ring tooth data plus planet count when known. |
| Center interface | Bore, key, spline or shaft features with functional datums. |
| Operating duty | Rated/peak torque, speed, reversals/shock, life and environment. |
| Material/process | Controlled material, heat treatment, finish and coating requirements. |
| Acceptance | Gear/runout/dimensional checks and required documentation. |
Pertanyaan yang sering diajukan
Can a visual match confirm interchangeability?
No. Similar outside dimensions can hide different pitch systems, pressure angles, profile shift or interface fits.
Should mating gear data be included?
Yes whenever available, because planetary geometry is easier to verify as a system.
What if a value is unknown?
Mark it as open and provide the available sample, mating component or application data rather than guessing.
Minta Penawaran / Kirim Permintaan Penawaran
Kirimkan gambar, data gigi, informasi komponen pasangannya, bea masuk, dan kuantitas. Kami akan meninjau antarmuka sebelum memberikan penawaran.
